Search results for: 'category tape'

  • Many cabinetmakers build jigs to speed up repetitive tasks. Installing thread escutcheons could well be a candidate for this approach. I have never been a jig enthusiast, either I'm too lazy or because I have seen too many craftsmen design work to suit existing tools, cutters and jigs rather than the other way around. A thread escutcheon is a short keyhole shaped brass tube that is set into a matching mortise. Our thread escutcheons are cut from long extrusions of the required section and are very cons...
  • Door & Drawer Locks Locate the center of the drawer front (or the appropriate position on the door if mounting a door lock). Using the lock as a template, mark its outline on the back and upper edge of the drawer front. Be aware that the key pin is usually offset to one side of the lock and it is the key pin that must be centered on the drawer. With a sharp knife, ruler and square go back over these lines. Use a router or chisel to create the shallow mortise for the lock plate (I use a 1/4" high s...