Search results for: 'category depth'

Your search 'category drlth' did not match any products. Did you mean:  'category depth'

  • Door & Drawer Locks Locate the center of the drawer front (or the appropriate position on the door if mounting a door lock). Using the lock as a template, mark its outline on the back and upper edge of the drawer front. Be aware that the key pin is usually offset to one side of the lock and it is the key pin that must be centered on the drawer. With a sharp knife, ruler and square go back over these lines. Use a router or chisel to create the shallow mortise for the lock plate (I use a 1/4" high s...
  • It helps to remember that a quadrant hinge is simply a butt hinges with integral lid stay. The same rules that apply to installing a butt hinge apply also to the quadrant hinge. Many jigs are now available to speed up the installation of these hinges. Some are particular to a single brand of hinge and some claim to be universal. Unless you expect to install dozens of these hinges the purchase of a jig is probably not worth the investment. The tool that you will need is a straight cutter the same diamete...
  • Many cabinetmakers build jigs to speed up repetitive tasks. Installing thread escutcheons could well be a candidate for this approach. I have never been a jig enthusiast, either I'm too lazy or because I have seen too many craftsmen design work to suit existing tools, cutters and jigs rather than the other way around. A thread escutcheon is a short keyhole shaped brass tube that is set into a matching mortise. Our thread escutcheons are cut from long extrusions of the required section and are very cons...
  • Fiche hinges are common on Continental European furniture. We supply French made hinges in a variety of sizes to suit most applications. These hinges consist of two rolled steel tubes capped on opposing ends by decorative tips. One tube carries a fixed pin, the other slips over this pin. The tubes are formed with tangential flaps, the flap on the lower tube projects from one side and on the upper tube the other side. We have found three techniques that can be used to install these hinges. Firstly the c...